Cover Pillow Using Winnie The Pooh Fabric – Wonderful children’s fabric with drawings of Winnie the Pooh and his friends Suitable for cover pillow and furniture. We start with a simple tutorial how to sew fine cushion without rooting with zippers. The idea is that the pillow be closed with Winnie the pooh fabric and one overlapping opening. This method does not even require a measuring tape.
Cut out a strip that is slightly wider than the pillow, There should be so much Winnie the pooh fabric over on each side so that the seam fits. The second measure will be the cushion width times 3. Here you can totally skip to mind seam allowance. Zigzag around the cloth so that the fabric does not fray. On each short side, fold the edge twice. About 1 cm each bay, Pin the fold and sew.
Now, fold the Winnie the pooh fabric around the pillow again stuck with the wrong side outwards and needles fixed so my opening / molten end up where you want it. Once you have symmetry, pull out the stops pillow again. It is because the pillow to get the shape you wants. Either a little loose or tight fit. Sew the side openings of the sewing selected with the RS still inside. Turn the pillow right side comes out again and put the pillow in the overlapping opening. If you want, you can put a button that holds together the opening even more, but because of the overlap here is so deep will still not cushion to glimpse forward. In this case the ports themselves open near the edge of the pillow. If you reduce it down a bit on the length (i.e. the length you multiplied by 3), you can get the opening to end up in the middle instead.