Home Dog Yard Ideas

Prefab fence panels – To installing prefab fence panel’s first step is drive wooden stakes into the ground where you want to place a corner kick. Second measure from the first corner along your walls line a distance equal to the width of your fence panels. Mark the spot with a piece of tape around the mason line. Third dig post holes corresponding to one third of your post above the ground.
Fourth cut your posts to the correct height for your fence panels using a circular saw. Fifth set a position in each hole. Fill each hole with 1/2 of an 80-pound bag of concrete. Add water to the hole with a garden hose and mix using a wooden stake. Sixth make posts with a level. Seventh place the panels in place against the posts starting at one corner. Panels will run from center to center of the posts with a panel butting up to the next. Attach each panel as you go. Can make minor adjustments. Eight places a piece of 1-by-4 lumber under the bottom edge of the panel to the space it slightly off the ground to prevent moisture wicking up the prefab fence panels.
Ninth set vinyl, aluminum or PVC fence with the included bracket. Last adjust panels for installation on steep slopes by loosening screws or nails in the blockades to allow the panel to “rack” diagonally. Fasten runners to post on the uphill side of the panel and let the weight of the panel; pull the bottom edge down, parallel to the slope. Attach the downhill side. When the prefab fence panels are attached, tighten the screws.