Exterior French doors outswing – A French door has glass panels in wooden frames. Two French doors are often used for access to a courtyard, as they tend to have a more enjoyable than the sliding glass doors look and can provide more security. If space inside your home is limited, you can install doors overrun. These doors open out onto the patio instead of in the room. The installation process is essentially the same as putting on the doors opening. You can make this project easier by using pre-assembled doors. These are doors that are already in a frame.
Exterior French doors outswing check the threshold of the door frame to make sure it is level. Use a level. If the threshold is not level, shims nail until a threshold level reading is obtained. Place a strip of aluminum tape across the threshold so that it covers the front edge of the threshold and the front of the upper edge of the doorway. Use a piece of tape long enough to cover the bottom 2 inches of the side jambs and the threshold. Make a small cut on the tape at the corners where the threshold and jambs meet so that you can press the tape flat against the surface to prevent leakage.
Exterior French doors outswing place a second strip of aluminum tape on the threshold and jambs behind the first strip, overlapping the edges of the first strip. Apply two thick beads, zigzag silicone adhesive on top of the threshold. This helps to provide a waterproof barrier below the French doors.