Replacing sliding glass door with french door – The first thing we need to do is measure for replacement doors. To measure the lower, middle and upper door frame is there to find a narrow dimensions. Starting out, and measure at the point where it stops the old frames and outer material begins. Materials that can be stucco, walls or brick. The measurement is performed three areas: the lower, middle and upper. Record the smallest dimensions. Then go inside and do the same. To measure where the frame ends, and drywall, plaster or sheetrock begins. All six measurements, find the closest one and reduction of 3/4 “. This is the width of the door.
Now, if you replacing sliding glass door with french door, you can do so only outside. Measurement of left, center and right of the land where the bottom track sits, ends where it begins the old frame and outer material. Taking the narrow dimensions and cut 1/2 “. It is the height of your door. Then determine which side should be on a sliding panel. The panel will remain marked with the letter” O “, and the rider is” X “in most regions of the country, you’re talking about looking at the door from the outside and reading from left to right. So, if you’re out looking at your door you, and you want the slider to the right against the wall, you ask “OX”.
Next, you need to decide whether you want to limit the retrofitting or replacing the frame. If the old frame flush with the outer material, as is the case with plaster, then you want to get a retrofit frame that comes with external ribs. This will eliminate the need for trimming out. If you have a brick or siding surrounding the hole, then you need to get a replacement frame and trim off each other. You can use wood, vinyl, or other composite materials are available at most hardware stores network. It is also necessary to measure the depth of the old frame. Most replacing sliding glass door with french door has a depth of 4 3/4 “.