Prefab granite – Granite can complete any kitchen or bathroom look and prefabricated panels simplify installation because they are slice to fit certain sizes. Although the stone is especially hard to damage when installed, must be used for transport it. To lay stone slabs flat during transport can cause it to crack or break over bumps. By taking certain precautions, you can move your stones safely from the store to your home.
How transport prefab granite slabs, construct or purchase an A-frame to support your granite pieces. Move the stone by means of two persons or more if it is a particular paragraph. Lift it out evenly on the surface it is on. This should be done vertically, which means a side facing the ground, instead of the flat top or bottom. Put the stone on the A-frame, with the unfinished side against the tree to avoid damage to the visible polished side. For consignments of more than one piece of granite, you can use the same A-frame if it can support them. The polished sides of the granite should be against another polish side, so the unfinished stone side not mars the finish of the second piece.
Strap the stone slab to the A-frame. Tighten the straps as much as possible before moving. The simplest material for this is clamps or ratchet straps available at hardware stores. Ratchet straps have a mechanism to help you tighten built on a piece of tape. This method of tightening ensures the best fit, so the stone does not wobble. Minister prefab granite slab on the A-frame of a vehicle, large enough to hold it conveniently. Discharge granite in the same way you put it. In that the vertical. Be careful when entrapping plate from the A-frame, so it does not fall.