Tropical Backyards Decor

You cannot install a bath towel rack in the same way as hanging a box or putting your toilet paper holder. Since the frame will be holding moist towels, it has to be very strong and safe, even when it is frequently bumped and cooed by hand washers and bathers. This means that it is important to pass at least one end of the frame on a bolt rather than simply on the drywall. A bathroom towel rack, excellently located, is an additional bath that can actually free up storage space while serving the dual purpose of displaying the favorite towels for that “spa vacation” look.

The basic plan for a towel rack can be adjusted to fit any size of the bathroom and any amount of towel storage. In addition, the bathroom towel rack wooden can be constructed from materials that match the rest of the bathroom or painted to match the color of the room. Multiple shelves can be installed one on top of the other, side by side or on different walls. Locate the wood studs on the wall of the chosen bathroom using a beam detector. Use the pencil to mark the location of the wooden posts on each side of the beam border. Measure the distance from the center of one bolt to the next.

Set the top of the first category panel face 1 foot on the floor and position the wooden supports on the shelf the same distance as the study measurements. Mark the location of the screw holes with a pencil, and pre-drill the holes with a drill bit slightly smaller than the wood screws. Secure the wooden brackets with wood screws. Measure the distance between the inside of the wooden supports and cut the smaller, 3-inch wide board to fit inside them. Place this smaller board bathroom towel rack small between the supports, keeping it perpendicular to the top shelf plate and according to where the wall would be. Pre-drilled holes through the top of the top shelf board in the smaller board, which will serve as a place to install towel pegs to hang towels.

On one side, the joints attached form “L”. Attach the two boards together with wood screws. Place the wooden towel pegs on the smallest board in a uniform pattern. Mark your locations bathroom towel rack ideas with a pen, and pre-punched holes for your attachments. Secure the pins to the seat plate using the provided hardware, or simply attach with wood screws. Place the shelf unit against the intended location by aligning it with the stud bolt lines on the wall. Make sure the platform is level by carpenter level.